odm carbon fiber heat lamp for warming cooking device

Mon, 25 May 2026 21:45:03 +0800

We built this carbon fiber heat lamp for one reason: to warm up cooking gear that demands precise heat, in a package that doesn’t waste an inch. Here’s the thing—this thing cranks out heat fast, and it keeps the beam tight. It runs at high wattage on 400V, so it gets seriously hot without tripping the circuit. The tube is 300mm long, which means the heat stays focused in a small zone—perfect for crowded appliance interiors. You get a lot of heat in a small footprint. But that also means the chassis around it needs to be ready for the warmth. Plan your cooling and insulation spacing accordingly. The carbon fiber element fires up quickly and takes repeated on/off cycles without flinching. The quartz envelope handles the wild temperature swings, and the halogen gas inside keeps the filament steady, so the lamp lasts longer. Installation is straightforward. The R7s connector is a simple two-pin setup, so it drops right into many standard fixtures. Line up the pins, slide the tube in, and lock it down. Done. In cooking devices, the lamp puts heat exactly where you need it—speeding up preheat and holding steady temperatures during service. Because we built this as an ODM solution, we can match your layout, power needs, and terminal setup. You end up with a heat source that wires up clean, takes the cycling, and keeps the warmth concentrated on the cooking zone. And yes, it’s powerful. Respect the heat, size your thermal management properly, and it’ll do its job—consistently.

Device on IR Lamp Factory

odm carbon fiber heat lamp for warming cooking device